CNC Questions And Answers
I need the calculation to determine the stepper...
I need the calculation to determine the stepper motor torque to find the load that it can lift using a lead screw at 1/2" diameter with 13 TPI.
I need the calculation to determine the stepper...
I need the calculation to determine the stepper motor torque to find the load that it can lift using a lead screw at 1/2" diameter with 13 TPI.
If I am cutting 18mm MDF with 6mm cutting bit (...
If I am cutting 18mm MDF with 6mm cutting bit (so 6mm pass), what can be the maximum speed rate of cutting and spindle speed of router?
If I am cutting 18mm MDF with 6mm cutting bit (...
If I am cutting 18mm MDF with 6mm cutting bit (so 6mm pass), what can be the maximum speed rate of cutting and spindle speed of router?
My driver has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-. H...
My driver has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-. How do I connect the driver to my BoB.
My driver has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-. H...
My driver has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-. How do I connect the driver to my BoB.
My BoB has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-, instr...
My BoB has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-, instruct/book says term#2 to Pul- & term#3 to Dir-, sorry I'm lost
My BoB has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-, instr...
My BoB has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-, instruct/book says term#2 to Pul- & term#3 to Dir-, sorry I'm lost
Are there torque-speed curves available for the...
Are there torque-speed curves available for the NEMA 34 Stepping Motor (651 oz-in 1/2" dual shaft)?
Are there torque-speed curves available for the...
Are there torque-speed curves available for the NEMA 34 Stepping Motor (651 oz-in 1/2" dual shaft)?
Regarding L6203/L297 Stepper Board Driver, woul...
Regarding L6203/L297 Stepper Board Driver, would you be willing to sell two unpopulated boards? A friend and I are each building a low cost CNC and I already have most...
Regarding L6203/L297 Stepper Board Driver, woul...
Regarding L6203/L297 Stepper Board Driver, would you be willing to sell two unpopulated boards? A friend and I are each building a low cost CNC and I already have most...