[ Log In ]
thumbnail: 3 position female connector with 2.54mm pitch

3 position female connector with 2.54mm pitch

$0.55
Qty:
2x36 pin header IDC

2.54 mm (0.1") Pitch Male Connector 36 pin Header

$0.75
Qty:
Newbie Hack Shirt Back
molex connector with crimp pins thumbnail

4 Pin Female Molex Connector with Crimp Pins

$3.50
Qty:
9V Battery Hold with Wire Leads

9V Battery Holder with Wire Leads

$0.49
Qty:
USB 2.0 Cable 10 Foot Type A Male to Type B Male

USB 2.0 Cable Type A Male to Type B Male - 10 FT

$4.80
Qty:
3 Foot USB Cable Type A to USB Cable Type A

USB Cable Type A Male to USB Type A Male - 3 FT

$2.65
Qty:
Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

Multimeter Security Banana Plug To Test Hook Clip Probe Lead Cable 500V

$8.99
Qty:
Type K Thermocouple Temperature Sensor

Type K Thermocouple - Temperature Sensor

$4.95
Qty:
84 oz-in NEMA 17 Stepping motors (also called stepper motor)

2.54mm (0.1") Pitch Male Connector 36 pin Header

2x36 pin header IDC 2x36 pin header with mechanical pencil shown for scale
2x36 pin header IDC 2x36 pin header with mechanical pencil shown for scale

Introduction:

This connector will mate with female connectors that have a 2.54mm pitch (pin spacing) This 2x36 pin header is intended to assist with prototyping. Whether you need to connect or solder, these headers are breakaway: meaning they can be broken apart easily.

Description:

  • 0.1" (2.54mm) Pitch

2.54 mm (0.1") Pitch Male Connector 36 pin Header

$0.75
Qty:

Learn about the 2.54mm (0.1") Pitch Male Connector 36 pin Header

Orientation is key to inserting the crimp pin into the female header. There is a notch on the crimp pin and a flap on the female header that can be used to remove the crimp pin if necessary. This not...
A standard pair of needle nose pliers is used to crimp this crimp pin since this is the tool that most have rather than the more expensive crimping tool. The needle nose pliers is first used to clo...
Modifying headers so that the pins of the headers stick out farther from one end.
Soldering a wire to a metal pin of a header is tricky. The problem with simply soldering a wire to a metal pin is that the wire can easily break off of the pin. The solution is to create a mechanica...
Part 1: Making a convenient connector from a 2x3 female header to an inline 6 pin male header for SPI communication from USBTiny at the computer end to the microcontrollers MOSI, MISO, SCK, Reset, VCC...