[ Log In ]
3 Foot USB Cable Type A to USB Cable Type A

USB Cable Type A Male to USB Type A Male - 3 FT

$2.65
Qty:
USB 2.0 Cable 10 Foot Type A Male to Type B Male

USB 2.0 Cable Type A Male to Type B Male - 10 FT

$4.80
Qty:
84 oz-in NEMA 17 Stepping motors (also called stepper motor)
Image of the Atmega324p

Atmega324P

$8.50
Qty:

10K timmer potentiometer

10K Trimmer Potentiometer (Through Hole)

$0.85
Qty:
16x2 LCD (Liquid Crystal Display)

16x2 LCD (Liquid Crystal Display)

$12.50
Qty:
White prototyping breadboard with 30 tie strips and two power rails on each side.

White Prototyping Breadboard (2x30 columns of tie strips and 2x2 rows of power strips)

$7.95
Qty:
Clear Semi Transparent Breadboard

Clear Prototyping Breadboard (2x30 columns of tie strips and 2x2 rows of power strips)

$8.50
Qty:
Red Through Hole LED (Light emitting diode)

Single Red Through Hole LED (Light Emitting Diode)

$0.34
Qty:

FTDI TTL-232R 5V USB to UART (Serial) Converter

Serial to USB converter with Micro USB cable Micro USB Cable included with board Back view of USB to Serial Converter Alternate view of USB to Serial board USB to serial converter shown with caliper. The measurement reads 1.0665 inches. USB to serial converter shown with caliper. The measurement reads .6695 inches.
Serial to USB converter with Micro USB cable Micro USB Cable included with board Back view of USB to Serial Converter Alternate view of USB to Serial board USB to serial converter shown with caliper. The measurement reads 1.0665 inches.  USB to serial converter shown with caliper. The measurement reads .6695 inches.

Introduction:

FTDI TTL-232R USB to UART (Serial) Converter cable allows you to communicate through USB if you don't have a serial port.

Description:

This device will provide a Tx (Transmit) and Rx (Receive) functionality and 5 volt power from the computer through the USB. We have replaced the old version of this product to a newer, easier-to-use board that doesn't require soldering. Simply plug the micro USB cable into the board and the USB cable into your computer.

USB to Serial Converter

$10.95
Qty:

Learn about the FTDI TTL-232R 5V USB to UART (Serial) Converter

For a microcontroller to be able to transmit, a wire must be connected to the TX pin of that microcontroller and this wire should be connected to the RX pin of the other device. To be able to recei...
With UART (Universal Asynchronous Receiver/Transmitter) and USART (Universal Synchronous Asynchronous Receiver/Transmitter), microcontroller communicate using two data lines called RX and TX. Rx is u...
Introduction to programmers line the USBTiny and the Pocket AVR and that this device is plugged into the computer and to the microcontroller (chip) to transfer the program from the computer to the mic...
The USB from the computer can be used to power the microcontroller circuit. The USB power is already a regulated power source, but another regulator can be connected with this input power. It is also...
The UART communicates at a agreed upon speed set by the baud rate. This baud rate must be set in both the transmitting and receiving microcontrollers to work. Includes Code