Testing Soldered Connections (Specifically for MISO)
Testing soldered connections to make sure the solder is placed on the pads and pins properly between the two points of a wire and the pins that this wire is connected to and to make sure that the contextual pins (pins next to the soldered pins) and not connected or that no bridges were formed to these pins.. Meter is set to the ohms or continuity setting. Testing the MISO (Master In Slave Out) conections.
Comments and Additional Information
Have some code to share? Or additional information? Respond here:
You need to be logged in to save a response on this page. The response must be constructive, helpful, supplimentary or to correct the existing video, code or narrative content.