Newbiehack-Power-4Xaa-Battery-Holder-With-Wire-Leads

4 x AA Battery Holder with Wire Leads

$1.29

Qty:

9V Battery Holder with Wire Leads

$0.49

Qty:

molex connector with crimp pins thumbnail

4 Pin Female Molex Connector with Crimp Pins

$3.50

Qty:

3 position female connector with 2.54mm pitch

$0.55

Qty:

Thumbnail: A bundle of 65 jumper wires of various length and color. Bound together with the male connectors shown in the foreground.

Bundle of 65 Male to Male Flexible Jumper Wires

$8.95

Qty:

50K Potentiometer Panel Mount (Non Trimmer) With Knob

$2.45

Qty:

Jumper Wire Pack 140 Pieces Multi-Size Multi-Color

$6.75

Qty:

Tactile momentary push button switch 6 mm x 6 mm (through hole)

LED Button Tactile Switch

$1.89

Qty:

4 x AA Battery Holder with Wire Leads

4 AA Battery Holder with Wire Leads shown with mechanical pencil for scale.

Introduction:

This is a battery holder with 4 AA (1.5v) capacity for a total of 6 volts. The wire leads are 7.8 inches (200mm) long.

Description:

4 x AA Battery Holder with Wire Leads

$1.29

Qty:

Learn about the 4 x AA Battery Holder with Wire Leads

Powering the Differential Pressure Sensor Using the MAX603 5v Voltage Regulator

The pressure sensor is connected to the MAX604's output voltage to pin 2 of the sensor for VCC and pin 3 for GND.

Breadboarding: Potentiometer (Voltage Divider) to ADC (Analog to Digital Conversion)

The center lead (Vout) of the potentiometer is connected to the ADC pin 0. The potentiometer's outer leads are connected to ground (GND) and 5V (VCC). These connections create the voltage divider. O...

On Paper: Voltage Regulation (Bring the Voltage Down to the Circuit's Operating Voltage)

A voltage regulator takes a higher voltage and provides a set voltage that the regulator is designed to output. There are a few types of regulators: switching regulators, high dropout regulators and ...

Soldering a wire to Perf Baord (Specifically for VCC)

Soldering a wire from one location on a perf board and to a header pin to another location on a perf board and to a header pin using a wire stripper, soldering iron, perf board and solder. Specificall...

Connecting Power All Around a Breadboard (2 Breadboards)

Connecting two breadboards and powering all of the GND - and VCC + rails on the breadboards. Wires are connected between the two breadboards and wires are connected between the upper and lower rails...

Learn the Fundamentals of Mechatronics!

4 x AA Battery Holder with Wire Leads

Learn about the 4 x AA Battery Holder with Wire Leads